Finish: Matt
Application: By Brush, roller, conventional spray
Thinning: It is recommended that clean water be used to thin to facilitate brushing, good flow and eliminating brush marks. The first coat which is usually regarded as a sealer should be thinned slightly more than subsequent coats.
Drying time: Touch Dry: 10-15 minutes Re-coating Time: 2-3 hours
Cleaning: Clean all equipment with water
Colour Range: Available in a wide range of colours from DuraCoat Colour Card and
DuraCoat Classic Fan Deck.
Pack Sizes: 1 litre, 4 litres, 20 litres
SPECIFICATIONS
Ensure surface to be painted is clean, dry, and free from dusts, grease, oil or any loose
material.
a) New Cement or Plaster Surfaces: If the surface is dry and absorbent, the first coat should be thinned with up to 10 % of water. Follow up with one or two coats of unthinned paint. Where one coat is recommended, avoid thinning altogether.
b) Brick and Asbestos Surfaces: These should be sealed with one coat DuraCoat Acrylic Sealer to reduce absorption followed by two coats of DuraCoat Fungicidal Emulsion Matt.
c) Previously Painted Surfaces: If the existing paint work is in good condition, then the surface should be cleaned, sanded down before applying two coats of Duracoat Fungicidal Emulsion Matt.
Please note:
➢ When over coating a dark shade with a light shade, three coats may be required.
➢ On dark shades like bright Reds, Greens, Oranges, an additional coat will be required as some shades have low opacity. Alternatively, a Duracoat Emulsion Undercoat of a similar colour could be applied before applying the final coats of paint finish.
➢ Due to technical constraints, certain dark colours tend to fade if exposed to UV light especially in tropical climates. For further details contact our Technical Service department